Smartcast RF40 Humminbird

The Humminbird (r) SMARTCAST (tm) Channel Remote Sensor is designed for use with the SMARTCAST (tm) wireless Fish Finder . The Remote Sonar Sensor attaches to a standard rod and reel so you can cast it into the water. It transmits and receives a sonar signal and then wirelessly transmits the signals to the display unit. The images are displayed on the display unit like a conventional Fish Finder . Display unit required and not included.

RF40A
The "A" Remote Sonar Sensor is a replacement for the sensor that originally came with your SMARTCAST Wireless Fish finder .

Simply set your display unit to Channel A and start fishing . If you would like to use another Remote Sonar Sensor in close proximity to the "A" sensor, purchase a "B" model sensor.

RF40B
The "B" Remote Sonar Sensor will allow you to fish in close proximity to an "A" model sensor (the type of sensor that originally came with your SMARTCAST Wireless Fish finder) with reduced signal interference.

Simply set your display unit to Channel B and start fishing.

RF40 Features
• Ultra-wide 90 degree sonar beam
• Fully waterproof
• Typically lasts 400 hours of in-the-water usage
• Wet Switch™ technology maximizes battery life
by automatically shutting down when Remote
Sonar Sensor is out of the water
• Depth capability of 100ft.
• Operating frequency of 115 kHz

Note: Not intended for ice fishing or use in below freezing temperatures. Specifications subject to change without notice.